new life for your pool

Applying paints correctly for maximum performance.

  1. Introduction:

In order to get a lasting result with paints on a pool there are 3 key things to follow and a few others that assist.

  1. Three Key factors:
  • The surfaces need to be clean; no fats, oils or dirt etc
  • The surfaces need to be stable: no drummy, soft, worn, blistered areas.
  • The product needs to be mixed, applied and allowed to cure correctly.
  1. Note as follows: (Full details in the Application Notes)
  • Use detergent and water to clean surfaces, NOT acid.
  • Remove any suspect surface: blisters, drummy areas, weak and worn areas, any cement surfaces showing rust stains.
  • Repair defects using materials designed for water IMMERSION, not external or internal use.
  • Before coating, any surface moisture is to be removed, though damp surfaces okay so long as warm sunny day is happening.
  • Do not apply if SURFACE (not air) temperature is below 13 C and falling. Use infra-red thermometer to check surface temperature.
  • Apply coatings in the morning so as to finish by 12 noon (winter) 1 pm (summer) times. If you apply later may not cure before evening dew and thus a white bloom may occur.
  • Mix by power mixer thoroughly and use immediately after mixing. 
  • We advise to mix enough material usually half of the pack to do “cut ins” corners and steps first. Use the following ratio 4 parts of part A (Resin) to 1 part of Part B (Hardener), by weight. Example:  2kg (half of supplied Part A) will need 0.5kg (half of supplied Part B).
  • When applying do about 1 – 2 sq M per application. Roll (brush) into an “H” pattern to spread the paint around and lap adjoining areas. See attached sketch.
  • Note that life is related to dry film thickness, so MAKE sure evenly spread out. Otherwise some areas will wear away too soon and others will last much longer.
  • Allow to cure without dew, rain, for 12 – 24 hrs between coats or longer in winter, but no more than 72 hours.
  • After last coat wait 5 days (summer) 7 days (winter) before filling and adding chemicals. ( if you need to fill sooner, call us first)
  • Dilute or dissolve ALL chemicals before putting into pool, inc salt.
  • Ensure pool water balance kept to our recommendations for maximum life.

Layout EPOTEC

  1. Loaded roller, middle of 1 x 2 M area, roll up or away to apply.
  2. Then roll on R and L sides to apply more coating.
  3. Roll across WHOLE area to move paint around and get uniform coverage.

(Repeat 2 and 3 if needed to make sure UNIFORM coating thickness).

  1. Lay off in ONE direction, usually down walls and towards you on floors.
  2. Move to next 1 x 2 M area and repeat, over lapping just completed areas by about 100 – 200 mm.

4. Summary

By following the key aspects detailed above (and those in the Application Notes) you will get a much better outcome. If not sure about anything, contact us before you start

Vertical banding, no L to R spread
Vertical banding as no L to R spreading, only vertical.
Roller lines visible on bottom
Not enough uniform spreading out , so worn off too soon in some areas.